Fiat 500 Replacement Key Fob
If your 500 remote key fob has stopped working, it may be time to replace the battery. If you do replace the battery but it does not work then the issue could be elsewhere.
At United Locksmith, we specialize in making new keys for old automobiles. We have all of the tools and components needed for this service.
G28 Car Keys is the primary reason for your Fiat 500 keyfob not locking or unlocking the doors. The battery of the coin cell inside the key fob will deplete quickly when you don't use frequently enough. If your remote is beginning to show signs of a loss in range or stopped functioning or not responding, then the battery could be dead.
The battery in the key fob is held in place by steel clips for retaining. If the clips are loose it can cause contact issues which will prevent your remote from receiving power. Use a flathead screwdriver to open the retaining clips and remove the old battery. Make sure you use a replacement battery with the same kind of voltage, the same size and specifications as the original battery.
The key fob might also become corroded or damaged by water exposure. Even a small shower in soapy water can harm the electronic chip within. Keep your key fob dry.
Water Damage
If your key fob isn't operating correctly, it could be due to water damage. The rubber seals on key fobs stop them from getting damaged by a slight drizzle or splash of water. However, it is important to keep the keys from the ocean, washing machine, and even the pool.
The key fob comes with an electronic chip inside it that sends a signal to your car's immobilizer system. The chip is what allows the 500 to start and lock. If it gets wet, it will no longer work.
You can clean your key fob's internal electronics with isopropyl Alcohol or an electronic cleaner to see if they are still good. However, it is probably better to purchase a replacement from a dealer rather than trying to repair a key fob that has been submerged by salt water.
While a replacement fob might cost you a little bit of money, it is far less expensive than paying for your Fiat 500 to be towed to the dealership and repaired! You can also do it yourself with a few easy steps. Be sure to have the correct type of battery prior to opening your key fob. There are step-by-step directions for any car keyfob online.
Faulty Chip
The chip in the key fob communicates with your car's immobiliser unit to ensure the vehicle is able to start when the correct key is used. If the chip is damaged or corrupted in any way the car won't start.
A chip that is defective can happen due to a variety of reasons but most often it is due to water damage or an unresponsive battery. It is recommended to leave the job to a professional locksmith, who can replace the chip in a short time and at a a reasonable price.
If your key fob will not function after being exposed to clean tap or rain water take it off the battery. Clean the electronic component with paper towels. If the key fob fails to work it's most likely to be a damaged chip that must be replaced.
Some people will visit their dealer in order to get a new Fiat fob. But, this can be expensive. United Locksmith is the best place to go if you would like to have your Fiat key fob repaired at a reasonable cost. We have the tools and knowledge required to repair your Fiat fob quickly and professionally. way.
Faulty Receiver Module
Fiat key fobs send an electronic signal to the vehicle that can unlock and close doors (and start the vehicle for those with an automatic transmission) up to 50 feet. There are many reasons why a fob could not function. These include a dead coin battery damaged by water buttons, worn out buttons and a receiver module issue and signal interference or a malfunctioning electronic chip.
If the fob was in an area that has experienced extreme trauma (such as being dropped on the hard floor or washed in the washing machine), it may not be able to connect with the Body Control Module (BCM) of the car. The BCM is a security device that only accepts signals from genuine keys.
If this is the case, you must replace your fob. A professional locksmith can handle all aspects of the key replacement procedure and even program a new one for the 500. They can even provide you with a clone fob that works the same as the original (and costs less than the cost).